How to disassemble the screw of the oil press?

Sometimes the oil press needs to be disassembled when it breaks down, so you must master the disassembly skills.

The main pressing part of the screw oil press is the screw. The screw is the part that contacts the oil the most. Long-term pressing will inevitably cause some problems with the screw. Sometimes the screw needs to be replaced. At this time, you need to understand some matters about the disassembly and installation of the screw.
The main pressing parts of the screw oil press include round rows and strip ribs. The strips of the oil press are strip-shaped stainless steel parts. The disassembly method is to knock on one side with a hammer and take it out from the other side.
Installation method of the oil press strips: Stand up the oil press strip ring, with the oil tank facing down, put a wooden board underneath, and align the strips on the inner wall of the strip ring, with the end with the deep oil tank facing down. The deep oil groove surfaces of two adjacent bars cannot be placed together. Finally, use a metal rod to push the inner side of one end of the oil press bar plug against the protruding end, and hit the other end with a hammer to make the bar close to the inner wall until there is no protrusion on the inner wall.

How to remove the screw: When the oil press is stopped, you can grab the handle, pull the press shaft out of the press chamber, and remove the protective cap, nut, bearing and bolt. Use a 16mm diameter iron rod to penetrate the hole of the locking nut and rotate it counterclockwise. After removing the locking nut, all the screws can be easily removed. If the screw is removed, it can be heated with a fire stick before removal.

Summary: The disassembly and assembly of the screw oil press is mainly complicated. Pay attention to the order of disassembly and assembly to avoid failure during installation. The screw bars can be numbered.
 

Oil press machine peanut oil press plant Soybean Oil Press Machine Castor Oil Production Plant