◉ Common problems and solutions at startup
When the oil press starts running, if too much material is added, you can try to feed slowly with fried oil seeds and eliminate the problem by repeatedly grinding the machine.
◉ Problems and solutions during pressing
If the material is broken in the pressing chamber during pressing, this is usually caused by a large amount of oil added at one time. To avoid this, ensure that the feeding is continuous and uniform. Once a blockage occurs, the power supply should be cut off immediately, the feeding should be stopped, the discharge plate should be opened, the screw shaft should be withdrawn to clear the oil in the chamber, and then the pressing should be restarted.
◉ Equipment protection mechanism
In addition, the pressing cage of the large screw oil press is equipped with a scraper, whose blade is deep into the pressing chamber and aligned with each distance ring, aiming to prevent the embryo from sliding or rotating in the pressing chamber. At the same time, the scraper can also adjust the thickness of the cake, thereby controlling the pressure in the pressing chamber and reducing the residual oil rate. The machine is also equipped with a cake clamping mechanism to ensure the smoothness of the slag cake surface.
.jpg)