1. Material problem
1. Too much material: If we put too much material in the oil press, it will easily cause the oil press to not produce oil. Because the oil press cannot withstand too much pressure, and too much material will cause excessive pressure, affecting the normal operation of the oil press.
Solution: We should put in an appropriate amount of material according to the requirements of the oil press, and do not exceed the maximum capacity to ensure the normal operation of the machine.
2. Too little material: Too little material will also cause the oil press to not produce oil, because the oil press requires a certain pressure to squeeze out the oil.
Solution: We should put enough material in the oil press to generate enough pressure to ensure the normal operation of the machine.
2. Machine failure
1. Filter blockage: The filter of the oil press is covered with oil or debris, which will cause the oil to be unable to flow out.
Solution: We need to clean the filter to remove the oil and debris.
2. Wear of compression rod or pressing rotating bearing: After the oil press has been used for a long time, the compression rod or pressing rotating bearing will cause the machine to fail to produce oil normally due to wear.
Solution: We need to replace these parts or send them for repair and maintenance to ensure the normal use of the oil press.
3. Incomplete cleaning
1. Oil accumulation: Incomplete cleaning of the oil press will cause the oil press to fail to produce oil.
Solution: We need to thoroughly clean the oil press and remove the oil thoroughly.
2. Loose socket: Loose socket or poor wiring of the oil press will also affect the normal operation of the oil press.
Solution: We need to check whether the socket and wiring of the oil press are firm to ensure that the socket is tightly connected.
In short, the failure of the oil press to produce oil may be caused by many reasons. Only through careful inspection and correct operation can we ensure the normal use of the oil press.
.jpg)
.jpg)
.jpg)
